Packet Tracer 9.3.3 Hsrp Configuration Guide ((install)) -

Router2>enable Router2#configure terminal Router2(config)#interface FastEthernet0/0 Router2(config-if)#ip address 192.168.1.2 255.255.255.0 Router2(config-if)#exit

Router1#shutdown Verify that Router2 has taken over as the active router. Use the following command: packet tracer 9.3.3 hsrp configuration guide

Test the HSRP configuration by shutting down the active router (Router1). Use the following command: packet tracer 9.3.3 hsrp configuration guide

Router2#show standby You should see that Router2 is now the active router. packet tracer 9.3.3 hsrp configuration guide